Qualified Acton, MA Concrete Repair & Radon Mitigation Company

A homeowner in Acton, Massachusetts, has lived in their 1700s home for the past 30+ years. They had a failing waterproofing system in their basement that was allowing some water to enter their basement. Over the last couple of years, the homeowner has seen more and more water entering their basement. The homeowner decided to call EFS for a free inspection. Our Design Specialist Liam inspected the basement and recommended installing a better waterproofing system that included perimeter drainage, a sump pump, CleanSpace, and a dehumidifier, and then replacing some supports in the basement. 

Our installation team began by installing 5 SmartJacks to the floor system of the 1700s home to add support. Next, the team began chipping out concrete for the sump pump and perimeter drainage. The team chipped out a total of 110' of concrete so we could install out TripleSafe, WaterGuard, and TrenchDrain. Once the concrete was chipped out the team installed our TripleSafe and plumbed the system to the exterior of the home. After the sump was installed, the team then installed CleanSpace on the wall before we installed the perimeter drainage. The CleanSpace will collect any water that enters the basement through the wall and guide it into the drainage system. Once the CleanSpace was integrated into the perimeter drainage and the drainage was connected to the sump pump, the team then encased the drainage system and the sump pump in concrete. The final part of the job was to wait for the concrete to cure and install the SaniDry Sedona and connect the drainage line to the sump pump. 

The homeowner was very pleased with the results of the project. The homeowner now doesn't have to worry about water entering their basement anymore. 

A homeowner in Acton, Massachusetts, had just purchased their home 2 weeks ago. A home inspector looked around the entire home to ensure that the home was in good standing. The home inspector noticed that the lally columns in the garage were rusted at the top and they were supporting a main beam. The homeowner decided to call EFS for a solution to there rusted lally columns in their garage. Our Design Specialist recommended replacing each lally column with 4 SmartJacks. 

Our installation team began by setting up temporary posts between each of the lally columns so they could remove them safely. After the old lally columns were removed the team then chipped 4 footings, one for each SJ. The team makes the footings 24"x24"x24" and installed rebar and engineered fill before casting the footing with concrete. Once the concrete footing has cured the team installed the SmartJacks over the footings and attached them to the main beam. The team made sure everything was level before encasing the SmartJack footing in concrete to lock it in place. 

The homeowners were very pleased with the results of the SmartJack Installation. 

A homeowner in Acton, Massachusetts, had lived in their 1769 home since last October and decided they wanted to gut the kitchen and remodel it. The homeowners wanted to ensure that the old floors could handle the weight of the new counters and appliances so they wanted to have the beam and floor joists looked at by a professional. The homeowner decided to call EFS for a free inspection of the floors in the kitchen and our design specialist recommended installing 4 SmartJacks and CleanSpace into the crawlspace beneath the kitchen floor. 

Before our production team arrived at the home, the homeowners had someone install a new support beam and joists under the kitchen floor. After the new beam and joists were installed, our team arrived at the home and began prepping to install the SmartJacks under the main support beam. Our support posts will add reinforcement to the beam so that the kitchen upgrades will be well-supported. The team began by removing some dirt in the crawlspace so they could create a footing for our SJs. They poured concrete into a 2' x 2' x 2' hole that was lined with engineered fill and rebar. The team dug 4 holes that were exactly the same and positioned them under the beam. Once the concrete was set, the team secured the SJ footing to the concrete and then secured the support column to the beam using our top bracket and heavy-duty screws. After the support posts were installed the team then began by installing CleanSpace in the crawlspace under the kitchen. The team used CleanSpace as a vapor barrier to prevent moisture and pests from entering the crawlspace. 

The homeowners were happy that they don't have to worry about the floors under their kitchen because they were reinforced with a new beam and SmartJacks. 

A homeowner in Acton, Massachusetts, recently had some friends tell them about a radon system they installed in their home because of high radon levels. The homeowners hadn't heard of radon before and did some light research on the effects of radon gas on the human body. After some research, the homeowners decide to call EFS for a free radon inspection of their home, and our design specialist recommended installing 2 radon mitigation systems with 3 extraction points into their home. 

Our team began by drilling the 3 extraction points in the slab in the basement. The extraction points were installed far away from each other to collect as much radon gas as possible. The team used a core drill to make a clean cut through the concrete to make each extraction point. Once each extraction point was created, the team attached a PVC pipe to collect radon from underneath the home. The team will install two radon fans to the exterior of the home, so one extraction point will go to one of the fans and the other two extraction points will go to the other fan. So the team will connect the corresponding extraction points to the correct fans. Once the extraction points were connected to the radon fans, the team then used more PVC pipe to vent the radon systems above the roofline of the home. The team took the radon levels from 4.6 pCi/L to near 0.

The homeowner was very happy with the results of the project. They no longer have to worry about the health concerns associated with radon gas. 

This homeowner in Acton, Massachusetts had recently learned about the harmful effects of radon. They would like to have their house tested for radon. They would like to be conscious of their long-term health, so they decided to call EFS for a test and a free inspection. 

Design Specialist Michael Bradley dropped off a CRM test two days before his appointment with the homeowners. The CRM takes 48 hours to conduct a proper test of the levels of radon in the air. After the test is complete, Michael inspected the home to see if there are any cracks in the foundation or slab. The result of the test came back around 7 pCi/L which is above the recommended amount. Michael recommended installing a radon mitigation system in the home. 

Crew Lead Dillon Kingbury and his team arrived at the home and installed a radon mitigation system into the home. 

This homeowner in Acton, Massachusetts was experiencing a large crack in his brick foundation wall. The homeowner travels for business and doesn't want to worry about the problem getting worse when he is away. He decided to call EFS for a free inspection. 

Design Specialist Michael LaMalfa inspected the interior and exterior of the home. Michael confirmed that there is a large crack on the brick foundation wall. Michael explained to the homeowner that a crack this size on a brick or block foundation wall can diminish the integrity of the wall. Michael recommended demolishing the cracked wall and building a new block foundation wall. 

Crew Lead Branden Edwards and his team arrived at the home. They prepped the area with support posts and demolished the wall. After the team cleaned up the demoed wall, they began building the new block foundation wall.

A homeowner in Acton, Massachusett was experiencing some sinking around their pool deck. They decided to call Erickson Foundation Solutions about a free inspection. The homeowner plan to build a new pool within the next 10 years but in the meantime, they want to repair what they have. 

Design Specialist Isaac Hernandez arrived at the home and inspected the pool deck and found there are certain areas that a sinking. Isaac recommended that those areas that are sinking should be repaired using PolyLevel. 

Crew Lead Nick Melo and Installation Specialist Tyler Oslizlo arrived at the home and began injecting PolyLevel into the areas of the pool deck that had sunk. 

Moving to a new home takes a lot preparation and time. This is especially true when moving across the country. Jim G. was moving along with his family from Texas all the way to Acton, Massachusetts. After purchasing their new home, Jim was doing his best to ensure everything was prepared and ready for them upon arrival on move-in day. One of the items he needed to check off his list was installing a radon mitigation system, since the home did test high with levels more than 4.0 pci/l.

Jim reached out to Erickson Foundation Supportworks a little more than a month before their expected move-in date. Since he was out of state, he connected our team with his local realtor, who allowed our specialist to inspect the home and design an appropriate mitigation system.

The home had multiple zones in the basement area, and so two extraction points were required to properly mitigate the home. 

Our installation team was able to complete installation of the proposed radon mitigation system in a single day, and do so before Jim and his family arrived. By the time the new homeowners moved in, they had peace of mind knowing the air quality was improved and the dangers of radon were eliminated.